Home / Support / Answers

On my Smartcode Deadbolt, the Lock button does not lock the door.

No user codes are programmed.
If there are no codes in the lock, the lock button will not lock the door. Program at least one user code and test the Lock button again.
The door handing process was not executed.
Perform the door handing process, following the instructions inside the installation guide.
The battery is too low to lock the door.
This is indicated by the keypad flashing red three times with three beeps. Remove the batteries and replace with a fresh set.
The mounting plate is placing tension on the torque blade.
The clutch is disengaged.
For 913 - See page 10 here.
For 914 - See page 10 here.
Back to Top