Home / Support / Answers

How do I enable/delete the mastercode on my Smartcode?

Enabling and Setting the Mastercode
Programming timeout: If no button is pressed for five seconds, the system will time out and you will need to restart the procedure.
1. Keep door open. Press and HOLD the Program button until the keypad flashes green (about 5 seconds).
2. Enter new Mastercode.
3. Press Lock button once.
4. Re-enter Mastercode.
5. Press Lock button once.
If programming is unsuccessful, the keypad will fl ash red three times with three beeps. Make sure the Mastercode has not already been programmed. Attempt the procedure again, making sure to enter the same new Mastercode in step 2 and 4.
6. Make sure switch #3 is on, and press the Program button once. If you hear three beeps and
Note: The lock will time out after five seconds.

Disabling and Deleting the Mastercode
1. Keep door open. Press and HOLD the Program button until the keypad Flashes green (about 5 seconds).
2. Press Lock button once.
3. Enter Mastercode.
4. Press Lock button once.
5. Re-enter Mastercode.
6. Press Lock button once.
If programming is unsuccessful, the keypad will fl ash red three times with three beeps. Make sure the Mastercode has been enabled before trying to disable it. Attempt the procedure again, making sure to enter the same Mastercode in steps 3 and 5.
7. Make sure switch #3 is on, and press the Program button once. If you don’t immediately hear three beeps and see the keypad fl ash green three times, the Mastercode is disabled.
Note: The lock will time out after five seconds.
Back to Top