Home / Support / Answers

How do I add/delete a user code on my Powerbolt 2?

How to add User Codes
A total of 6 User Codes (and a temporary one-time User Code) may be programmed. Do not program a User Code that is the same as your Mastercode.

CAUTION: A User Code is used to unlock the door while a Mastercode is a password for making changes to the lock features.

1. Make sure the lock is unlocked and the door is open.
2. Enter your Mastercode - for new install, default is 0-0-0-0.
3. Press the lock button. You will hear one beep.
4. Press 1.
5. Press the lock button. You will hear one beep.
6. Enter a new User Code. It must be 4-10 digits.
7. Press the lock button. You will hear two beeps if successful. If you hear three beeps, it was unsuccessful. Repeat from step 1 slowly.
8. Test the code: While your door is open, lock it. Enter your new User Code, then press the lock button. The door should unlock.

How to delete individual User Codes
The lock is pre-programmed with a default User Code of 1-2-3-4. It is recommended that you delete this code.

1. Make sure the lock is unlocked and the door is open.
2. Enter your existing Mastercode.
3. Press the lock button. You will hear one beep.
4. Press 3.
5. Press the lock button. You will hear one beep.
6. Enter the User Code you wish to delete.
7. Press the lock button. You will hear two beeps if successful. If you hear three beeps, it was unsuccessful. Repeat from step 1 slowly.
8. Test the code: While your door is open, lock it. Enter the User Code, then press the lock button. The door should not unlock.