1. Slide cover up 2. Remove battery pack 3. Replace batteries Note: For Premis Traditional, use screw driver to remove the interior cover
Read MoreInstall Batteriesa) Remove interior cover. b) Connect 9v battery.c) Secure battery into interior assembly.d) Reinstall battery cover.
Read MoreNo. Kevo Smart Lock stores all information in memory so that when batteries are reinstalled, Kevo Smart Lock will return to the state that it was in before the batteries were removed.
Read MoreRemove interior screws Turnpiece must be vertical. Slide to remove the interior cover Remove the battery pack Replace the batteries Install battery pack Reinstall interior screws
Read MoreWhen the battery is low, the Kevo fob's LED will blink red. This will only be visible when the fob is in motion. Also, a solid red light will show up on the bottom of Kevo's light ring when you lock or unlock the door.TO CHANGE THE KEVO FOB BATTERY:1. Use a small coin to twist and pry apart the two halves of the Kevo fob.2. Slide the battery out from between the two contacts. Dispose of battery according to local laws and regulations.3. Insert a new CR2025 battery, sliding it between the two contacts so that the positive face of the battery touches the positive contact.4. Press the two halves of the Kevo fob back together, making sure they snap into place.
Read MoreNo, the Kevo fob stores all of the information in memory which does not require power. When you insert a new battery, it will work just like it did before the battery was removed.
Read MoreThe Obsidian deadbolt is powered by 4xAA batteries. For best performance, we highly recommend alkaline batteries from a major brand. Do not use re-chargeable or lithium ion batteries.
Read MoreRemove the cover of the back of the unit by sliding it up and off and change the batteries. The link below will provide instructions on how to change the batteries. Click here
Read MoreIf the 4 AA batteries are too low to operate the lock, use a 9-Volt Alkaline battery to temporarily power the lock. Make sure both terminals on the 9-Volt battery touch the terminals below the keypad. When lock has enough power you will hear 3 short beeps. Hold the 9-Volt in place while entering your user code to unlock the door. Continue holding the 9-Volt in position until the door unlocks. Note: If you remove the battery before the door unlocks, you will need to re-enter your user code Remove the terminal cover Hold the battery to the terminals. You will hear beeping to signal you can open door. Press the battery firmly against the terminals, it will beep 3 times. Keep holding the battery firmly and enter your User Code and press the lock button to unlock Replace the terminal cover
Read More