Answer

On my 905 Keyless Deadbolt, the lock doesn’t respond and the keypad doesn’t respond when touched (no beeping is heard).

1. Cables are NOT properly connected. Make sure cables are connected properly. 2. Batteries are drained. Install a fresh set of batteries.

Read More

Answer

On my 905 Keyless Deadbolt, the lock beeps 4 Long Beeps when the keypad is touched but it cannot be locked/unlocked

Door handing has not yet been set. Follow the instructions for left or right door handing.

Read More

Answer

On my Smartcode Deadbolt, the Lock button does not lock the door.

No user codes are programmed. If there are no codes in the lock, the lock button will not lock the door. Program at least one user code and test the Lock button again. The door handing process was not executed. Perform the door handing process, following the instructions inside the installation guide. The battery is too low to lock the door. This is indicated by the keypad flashing red three times with three beeps. Remove the batteries and replace with a fresh set. The mounting plate is placing tension on the torque blade. The clutch is disengaged. For 913 - See page 10 here. For 914 - See page 10 here.

Read More

Answer

On my Smartcode lever, the Lock button does not lock the door.

If there are no codes in the lock, the lock button will not lock the door. This is indicated by the keypad flashing red three times with three beeps. Program at least one user code and test the Lock button again.The battery is too low to lock the door.This is indicated by the keypad flashing red three times with three beeps. Remove the batteries and replace with a fresh set.The set screw in the lever was not fully tightened.Fully tighten the pre-installed set screw at the bottom of the interior lever.

Read More