Answer

How do I add/delete a one-time User Code on my 264 Deadbolt?

A one-time user code may be used only once, and then it will be deleted immediately after use. Make sure your door is open and unlocked1. Enter your existing PC (Programming Code).2. Press "Kwikset" then "9" then "Kwikset"3. Enter a new User Code. It must be between 4 and 10 digits.4. Press "Kwikset"For all programming sequences, success is indicated when the Kwikset button flashes green 2 times and you hear 2 beeps.If unsuccessful, the Kwikset button will flash red 3 times and you will hear 3 beeps.Note: If the lock is muted, you will not hear the lock beepingIf User Codes are disabled (example: when you go on vacation), the lock can only be operated by the key and turnpiece until they are enabled again.Make sure your door is open and unlocked1. Enter your existing PC (Programming Code).2. Press "Kwikset" then "8" then "Kwikset"3. Repeat steps 1 and 2 to enable or disable the codes again.For all programming sequences, success is indicated when the Kwikset button flashes green 2 times and you hear 2 beeps.If unsuccessful, the Kwikset button will flash red 3 times and you will hear 3 beeps.Note: If the lock is muted, you will not hear the lock beeping

Read More

Answer

How do I add/delete a one-time User Code on my 275 Contemporary Deadbolt?

How to add a one-time User Code A one-time user code may be used only once, and then it will be deleted immediately after use. 1. Make sure the lock is unlocked and the door is open. 2. Enter your existing Programming Code. 3. Press enter arrow. You will hear one beep. 4. Press 8. 5. Press enter arrow. You will hear one beep. 6. Enter a new User Code. It must be between 4 and 10 digits. 7. Press enter arrow. You will hear two beeps if successful. If you hear three beeps, it was unsuccessful. Repeat from step 1 slowly. How to delete individual User Codes The lock is pre-programmed with a default User Code of 1-2-3-4. It is recommended that you delete this code. 1. Make sure the lock is unlocked and the door is open. 2. Enter your existing Programming Code. 3. Press enter arrow. You will hear one beep. 4. Press 2. 5. Press enter arrow. You will hear one beep. 6. Enter the User Code you wish to delete. 7. Press enter arrow. You will hear two beeps if successful. If you hear three beeps, it was unsuccessful. Repeat from step 1 slowly. 8. Test the code: While your door is open, lock it. Enter the User Code, then press the Lock symbol. The door should not unlock.

Read More

Answer

How do I add a one-time User Code on my Powerbolt 2?

How to add a one-time User CodeA one-time user code may be used only once, and then it will be deleted immediately after use.1. Make sure the lock is unlocked and the door is open.2. Enter your existing Mastercode.3. Press the lock button. You will hear one beep.4. Press 1 - 9.5. Press the lock button. You will hear one beep.6. Enter a new User Code. It must be 4-10 digits.7. Press the lock button. You will hear two beeps if successful. If you hear three beeps, it was unsuccessful. Repeat from step 1 slowly.

Read More